The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

3M 50gm Dry Guide Coat (2 Cartridges and applicator) - Black - 3M 51362

(No reviews yet) Write a Review
SKU:
M51362
UPC:
4046719802975
Availability:
Contact for lead time
Weight:
0.05 KGS
3M 50gm Dry Guide Coat (2 Cartridges and applicator) - Black - 3M 51362
£34.33 (Inc. VAT)
£28.61 (Ex. VAT)

3MTM Dry Guide Coat is a revolutionary method for applying a guide coat to a repair area. This system offers considerable advantages over current working practices. In particular, ease of use and achieving a better quality job every time.

  • Contains no solvents.

  • Requires no masking.

  • Gives total coverage of surface.

  • Applicator requires no cleaning.

  • Ideal for both wet and dry sanding systems.

3M Dry Guide Coat – Black provides a method of identifying surface imperfections such as scratches and pinholes in body filler and primer during the sanding process. These can be very difficult to see without the use of a guide coat and would subsequently impair the final finish causing rework. It is designed for use on polyester fillers and light to medium coloured primers. It works by giving a black contrast to the surface which indicates any defect, and will only be removed during the sanding process. Dry guide coat can be used with either wet or dry sanding methods. Dry Guide Coat – Orange can be used on darker or tinted primers where the black doesn’t provide a suitable contrast.

Directions for Use

1. Remove the kit from outer packaging

2. Identify tear strip on the plastic seal on the cartridge

3. Place finger in the centre hole of cardboard and remove

4. Place the applicator centrally onto the sponge pad in the cartridge and remove

5. Taking hold of the tab, remove the inner seal to reveal the 6 slots in the cartridge

6. Replace the applicator pad and sponge back into the cartridge

7. Holding the whole unit in both hands, shake up and down approximately 3 times, then twist the applicator from side to side in the cartridge. Repeat this process 2 or 3 times to ensure that the face of the sponge is coated with the powder. ( Failure to repeat this stage will result in very poor initial performance of the product) 8. Once the sponge is coloured with the powder, wipe the applicator and sponge over the surface 9. To reload the applicator repeat step 7. 10. Always replace the applicator in the cartridge to prevent accidental spillage